Activation and Deactivation

W4n Activation

  1. If the tag is connected to a charge source, disconnect it and ensure its LED is off—which may take one or two seconds.
  2. Plug the tag in the charger.
  3. When the LED turns on (green or red, depending on the charge level), press the tag’s single button.

In a moment, the LED will blink green to indicate the tag is active.

Note

If activation fails, the LED will blink red eight times. If this happens, repeat the activation steps.

W4n Deactivation

  1. If the tag is connected to a charge source, disconnect it.
  2. Plug the tag in the charger.
  3. When the LED turns on (green or red, depending on the charge level), press and hold the tag’s single button.

    After five seconds, the tag will buzz and blink orange. Keep holding the button.
  4. Release the button after the tag blinks green and red three times.

The tag is now deactivated and will completely shut down in a moment. When you remove the tag from the charger, it will not activate even if you pressed the button. To reactivate it, follow the activation steps above.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.